EC-PM-530B User's Manual
- 62 -
m: Ending ASCII code of user-defined character set. m
≤
127. The number of user-defined
characters is m-n+1, and the maximum number is 96. When user defines only 1
character, m=n.
a: The byte number of user-defined characters.
d1 d2…db: The data of user-defined characters. Every character has s×a bytes. m-n+1
characters altogether have (s×a) × (m-n+1) bytes (b=(s×a) × (m-n+1)).
The user-defined characters after being defined will be valid all the time until they are
defined again or the printer is turned off.
The format of each user-defined character data is shown as follows:
d1 d4 …
d2 d3 …
ESC
*
Select bit-image mode
Format: ASCII: ESC * m n1 n2
［
d
］
n1+256×n2
Decimal: 27 42 m n1 n2
［
d
］
n1+256×n2
Hex:
1B 2A m n1 n2
［
d
］
n1+256×n2
[Description]
This command is used for setting dot matrix figure mode (m) and setting the transverse dots number (n1,
n2) of dot matrix figure.
m=0, 1
0
≤
n1
≤
255, 0
≤
n2
≤
3, 0
≤
d
≤
255.
n1, n2 is hexadecimal figure with two bits. n1 is low byte and n2 is high byte. n1, n2 is used for denoting the
transverse dots number of figure printed by “ESC
*” command. This value should be within the number of
maximum line-width dots.
When m=0, normal printing is selected, the maximum number of printing dots is 210.
When m=1, half-dot printing is selected, the maximum number of printing dots is 420. On this condition the
adjacent dots cannot be “1” at the same time.
The definition of [d] is:
ESC
-
Set English underline mode
Format: ASCII: ESC
-
n
Decimal: 27
45
n
Hex: 1B
2D
n
[Description]
Set English underline mode
b7
Bit image data
The first pin
The eighth pin
Print data
EC Electronics, Ltd.
www.eclinepos.com
EC Electronics, Ltd
No. 221 Wai Yip Street, Kwun Tong
Kowloon, Hong Kong
TEL : (852) 3590 6397
FAX : (852) 3590 6497
E-MAIL : [email protected]
