9
Mana
4.
INSTALL & CONNECT
4.1
Wall Mount Install
The VEO-SWC44
can be installed on the wall or flat surface
. At the bottom of VEO-
SWC44, there are two mounting holes that can be fixed to a surface using flat screws.
Mounting screws are not included in the VEO-SWC44 box. The
type of screws
depends on the type of wall
(stone, wood, plasterboard, ...) you are mounting the Base
Unit VEO-SWC44 to.
Make sure the head of the screw is not larger than the hole in the
bottom of base unit VEO-SWC44
.
For optimal performance, install the VEO-SWC44 close to the display and avoid
obstacles between the VEO-SWC44 and the Transmitters.
Antenna Placement
•
The antennas should be
oriented vertically
, so perpendicular to the ceiling and
parallel to the walls.
•
The antennas
should be installed far enough (at least 50cm/1.6ft) from metallic
surfaces
to avoid unwanted reflections
and far enough (at least 1m/3.3ft) from
other radio equipment that operates in the same frequency range
, e.g. other
WiFi access points, cordless telephone, microwave ovens, etc. It is also best to
install antennas at least 15 cm (6 inches) from concrete walls.
•
The
most favourable situation is a direct line of sight between antennas and
buttons.
Any obstruction will cause the signal to follow a longer propagation
path, which can result in performance degradation.
•
Due to the particular radio pattern of the dipole antennas, the
antennas should
not be placed just above potential positions of VEO-SWC44 users
. As a result,
the advised position for the antennas is at the side of the meeting room.