ECKELMANN UA 300 D, Manual

Page: 74 / 108

Menu structure UA 300 D Controller type UA 111 XP
68 Version 2.03 27. Juni 2008
S
Screen 1−7 Cooling Zone 2
COOLING 2 POS: XXXXX
Cooling XXX
Current ON/OFF status of cooling Zone 2 Terminals 35/36/38
Run Time XX %
Cooling relay on time during last day (00:00 − 24:00 hours)
Starts X
Cooling relay actuations during last day
Setpoint R2.8 XXX °C
Supply air temperature setpoint for comparison
Hystersis R2.8 XXX K
Supply air temperature hysteresis setpoint
S
Screen 1−8 Defrost Zone 2
DEFROST 2 POS: XXXXX
Defrost 2 XXX
Current ON/OFF status of defrosting Zone 2
Def. End. Tmp. XXX °C
Defrost termination temperature for comparison
Last DefrstWe XX hh:mm
Day and time of last defrost cycle started
7.2.3 Menu 2 Setpoints
SETPOINTS POS: XXXXX
1 Cooling
Continue to Screen 2−1; Special case : when single−zone operation is set (Screen 6−1) and
setpoint toggle is disabled (Screen 3−3) Continue to Screen 2−1−1
2 Defrost
Continue to Screen 2−2; Special case : when single−zone operation is set (Screen 6−1) and
setpoint toggle is disabled (Screen 3−3) Continue to Screen 2−2−1
3
Not used with this controller type
4 Alarm
Continue to Screen 2−4; Special case : when single−zone operation is set (Screen 6−1) and
setpoint toggle is disabled (Screen 3−3) Continue to Screen 2−4−1
5 Compressor
Continue to Screen 2−5
S
Screen 2−1 Cooling
COOLING POS: XXXXX
1 Zone 1
Continue to Screen 2−1−1
2 Zone 2
Continue to Screen 2−1−2; shown only when two−zone operation is set (Screen 6−1)
3 Zone 1A Altern.
Continue to Screen 2−1−3; shown only when setpoint toggle is enabled (Screen 3−3)
4 Zone 2A Altern.
Continue to Screen 2−1−4; shown only when two−zone operation is set (Screen 6−1) and only
when setpoint toggle is enabled (Screen 3−3)