Echoflex Installation Guide
Open Loop CCT Sensor
Mount the Sensor
Use the adhesive pads on the bottom of the sensor to mount it to any
suitable surface.
1.
LED display
Rear View
Teach button
Adhesive mounting
pads (x2)
Clean the mounting
surface with an
alcohol wipe and
wait for the surface
to dry.
2. Remove the
protective backing
from the adhesive
pads on the sensor.
3. Press the sensor in place and hold for 30 seconds.
Link to a Controller
The compatible target controller must be installed, powered, and within
range of the FLS-41.
Note:
The linking process can be used both to link a device to a
controller and to unlink a linked device from a controller.
1. Press the
[Learn]
button on the controller to activate Link mode. If
necessary, refer to the controller product documentation.
2. Press the
[Teach]
button on the sensor once to send a link message.
An LED blinks to confirm a successful transmission.
3. Deactivate Link mode on the controller before attempting to link to
any other controllers.
Open Loop CCT Sensor
Page 3 of 8
Echoflex
