Echoflex Installation Guide
Elaho Preset Station
Change Button LED Color
Stations default to illuminating preset buttons in green. To change the
color of the LEDs at the station, follow this procedure:
1. Press and hold the [MODE] button for five seconds. The LED
beneath the [MODE] button illuminates and all of the preset
buttons display in their current configured color.
2. Press the first preset button to cycle through the available colors
until the desired color is shown.
• After 90 seconds of inactivity, the MODE status will timeout
and any changes are canceled.
3. Press and release the [MODE] button to save the setting. The station
preset buttons show their new selected color.
Preset Record
To record a preset to a button on the Preset Station:
1. Set the desired lighting look in the space.
2. Press and hold the preset button for three seconds. The preset is
recorded to the selected button. The button LED flashes four times
to confirm the record action.
Service
If you have any difficulties installing your system or with system startup
please, contact Echoflex Technical Services. Echoflex contact information
is located at the bottom of
.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received;
including interference that may cause undesired operation. Visit
for current and complete compliance
information including FCC compliance.
Elaho Preset Station
Page 8 of 8
Echoflex
