16
aIr
fIlter
Level
1.
Tools required:
25 - 50 mm (1 - 2 in.) Cleaning Brush
Parts required:
REPOWER
TM
AIR & FUEL FILTER KIT.
1. Close choke (Cold Start Position [
]). This prevents dirt from
entering the carburetor throat when the air filter is removed. Brush
accumulated dirt from air cleaner area.
2. Remove air filter cover. Brush dirt from inside cover.
3. Remove air filter and lightly brush debris from filter. Replace filter
if it is damaged, fuel soaked, very dirty, or the rubber sealing edges
are deformed.
4. If filter can be reused, be certain it:
• Fits tightly in the air filter cavity.
• Is installed with the original side out.
5. Install air filter cover.
NOTE
Carburetor adjustment may be needed after air filter cleaning/re
-
placement.
fuel
fIlter
Level
1.
Tools required:
200 - 250 mm (8 - 10 in.) length of wire with one
end bent into a hook, clean rag, funnel, and an
approved fuel container
Parts required:
REPOWER
TM
AIR & FUEL FILTER KIT.
dANGeR
Fuel is
VERy
flammable. Use extreme ca
re when mixing, storing
or handling, or serious personal injury may result.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and filter from the
tank.
3. Remove the filter from the line and install the new filter.
