CLUTCH SYSTEM
CS-310
40
5-3 Installing clutch assembly
1. Install worm gear (A).
2. Install clutch plate (B), facing rounded edge side
to worm gear.
3. Install clutch plate (C), facing the side with
punch mark “UP“ (c) to outside.
4. Install clutch assembly (D; Left-hand thread) to
crankshaft turning counterclockwise by hand until it
can not be turned further.
NOTE:
If starter assembly is installed, untie tempo-
rary knot holding starter grip (tied in the
fi
rst NOTE
of “5-1 Inspecting clutch parts”). While holding
starter grip, turn clutch assembly counterclockwise
until it cannot rotate further (piston touches piston
stopper).
5. Tighten clutch assembly with clutch tool
897505-16133 (E).
5-2 Replacing clutch parts
1. Install clutch spring (A) to clutch shoes (B).
2. Set one arm of clutch hub (C) to one clutch
shoe.
3. Install other two clutch shoes on two arms as
shown.
A
C
B
A
B
a
D
E
C
a
c
Summary of Contents for CS-310
Page 1: ...Ord No 401 33 CS 310 ...
Page 75: ...Printed in Japan 1101 ...
