REAR HANDLE AND CONTROL SYSTEM
CS-310
63
9-1 Replacing throttle trigger (continued)
5. Set torsion spring (F) on throttle trigger (E) as
shown.
6. Install throttle trigger (E) with torsion spring (F)
and insert spring pin (C) as follows.
1) Insert spring pin (C) in the hole of rear han-
dle so that tip of spring pin does not protrude
inside handle.
2 ) H o l d t h r o t t l e t r i g g e r ( E ) w i t h t o r s i o n
spring (F) in place, and insert spring pin tool
897724-01361 (D) from the other side of handle
through the hole of throttle trigger.
3) Lightly tap in spring pin (C), pushing out
spring pin tool (D).
7. Hook the inside tab (a2) of rear handle cover (A)
on the notch (g) of rear handle (G).
8. Push in hook (a1) and install rear handle cover
(A) on rear handle (G), setting torsion spring (F)
with throttle lockout (B) as shown.
9. Check throttle trigger and throttle lockout for cor-
rect movement.
F
E
E
F
C
D
a2
A
g
G
F
B
a1
F
Summary of Contents for CS-310
Page 1: ...Ord No 401 33 CS 310 ...
Page 75: ...Printed in Japan 1101 ...
