SAW CHAIN LUBRICATION SYSTEM
CS-310
47
7-3 Inspecting oil line
1. Remove starter assembly.
2. Remove screw (A).
3. Remove screw (B) of unit bottom.
4. Remove screw (C).
5. Remove front handle (D) and rear handle (E)
from engine unit.
6. Disconnect oil line (F) with joint pipe (G), from
oil grommet (H).
7. Connect pressure tester 897803-30133 (J) to
joint pipe (G) as shown.
8. Tighten oil cap and apply pressure approx. 9.8
kPa (0.1kgf/cm
2
) (1.4psi).
9. Pressure should not drop. If the pressure drops,
leakage may occur at oil cap, oil cap O-ring, mat-
ing surface of oil tank, oil line, grommet, or oil tank
vent. Inspect them and replace defective part(s)
with new parts as required.
D
B
E
A
C
F
G
H
J
G
Summary of Contents for CS-310
Page 1: ...Ord No 401 33 CS 310 ...
Page 75: ...Printed in Japan 1101 ...
