Echelon STRIDE-s, Instruction Manual

Page: 16 / 28

16 | BELT aDjuSTMEnT
Place treadmill on a level surface. Make treadmill
run at approximately 3-4 mph (6-8 kph), and observe
the running belt deviate condition.
SAFETY STRAPS, ANCHORS, & SCREWS SAFETY STRAP POSITION
BELT ADJUSTMENT: If the treadmill belt is swerving to the right, unplug the safety lock and turn off the
power. Turn the right adjusting bolt 1/4 turn clockwise, then insert the power switch and safety lock, make the
treadmill run, observe the running belt deviate condition. Repeat the above steps until belt is centered.
If the treadmill belt is swerving to the left, unplug the safety lock and turn off the power. Turn the left
adjusting bolt 1/4 turn clockwise, then insert the power switch and safety lock, make the treadmill run, and
observe the running belt deviate condition. Repeat the above steps until belt is centered.
The treadmill belt will gradually relax after above steps or after a period of use.
Unplug the safety lock and turn off the power, using the two adjusting bolts turn 1/4 turn clockwise.
Insert the power switch and safety lock to make treadmill run, then stand on the belt to confirm the tightness.
Repeat the above steps until the belt moderate tightness.
WHEN STORING THE TREADMILL
IN AN UPRIGHT POSITION, PLEASE
INSTALL SAFETY STRAPS TO THE
WALL TO SECURE AND PREVENT
TREADMILL FROM TIPPING OVER.
Use the provided anchors and screws to install the
safety straps. For concrete walls, drill two 0.315 in
(8 mm) pilot holes with 1.6 in (40 mm) depth, 32 in (81
cm) apart, and 47.2 in (120 cm) above floor. NOTE:
For wood walls, locate two wall studs 32 in (81 cm)
apart and drill appropriate pilot holes. Drive screws
into pilot holes without anchors.
32 IN (81 CM)
WIDTH APART
47.2 IN (120 CM)
ABOVE FLOOR
BELT ADJUSTMENT