English
English
10
Door spring resistance adjustment
1. The door springs are factory set to the correct resistance
for the outer door. If decorative panels are installed, it is
necessary to adjust the resistance of the door springs again.
Tighten or loosen the steel cable by turning the adjusting
bolt.
2. The resistance of the door spring is correct when the door
remains in the fully open position horizontally, but you can
raise and close it with a slight lift of a finger.
Dishwasher installation procedure
1. Attach the condensation strip under the work surface of the line. Make sure that the condensation strip is
level with the edge of the work surface.
2. Connect the supply hose to the cold water supply.
3. Attach the drain hose.
4. Plug in the power cord.
5. Place the dishwasher in the kitchen cabinet.
6. Level the dishwasher. The rear feet can be adjusted from the front of the dishwasher by turning the bolt in
the middle of the dishwasher base. Use a cross-head screwdriver. To adjust the front feet, use a flat-head
screwdriver and turn the front feet until the dishwasher is level.
7. Install the furniture door on the outer door of the dishwasher.
8. Adjust the resistance of the door spring by turning the cross-head screwdriver clockwise. Failure to follow
this procedure may cause damage to the dishwasher.
9. A dishwasher must be provided on site. This can be done in two ways:
A. A normal worktop: Insert the installation hook into the groove of the side and secure it to the worktop
with the bolts.
B. Marble or granite worktop: Fix the side with bolts.
