ECG EDF 6023 WA++, Instruction Manual

Page: 48 / 124

GB
48
• The outlet voltage corresponds to the one on rating plate of the appliance.
• The type of outlet matches the type of plug of the power cord of the appliance. Otherwise, ask an
authorized technician to replace the improper outlet. Do not use extension cords or power strips to
connect the dishwasher.
WARNING
• After installation keep the instruction manual.
• The manual contains important information.
USER’S INSTRUCTIONS
Prior to fi rst start of the operation
1. Before starting the dishwasher, you need to check the following items.
•
The dishwasher stands straight and fi rm.
• The intake valve is open.
• Hose connections do not leak water.
• The power cable is properly connected.
• The outlet is powered.
• The supply and drain hoses are not pinched or twisted.
• All packaging and labels are removed from the dishwasher.
2. Set the water softener.
3. Pour 1 kg of salt in the salt dispenser and fi ll it to the brim with water.
4. Fill the rinse aid dispenser.
5. Fill the detergent dispenser.
Water softener
The dishwasher requires soft water for proper functioning, that means water with
minimum calcium content. Otherwise, limescale deposits may remain on the dishes
and on the inner surfaces of the appliance. Hard water aff ects negatively the effi
ciency
of washing, drying and rinsing. The water fl owing through the softener is deprived of
ions causing hardness and is softened to a level needed to achieve optimal results. The
hardness of your water depends on the speed with which these ions accumulate in the
water softener system. It is therefore necessary to regenerate the softener system so that
it always keeps maximum effi
ciency. Salt added to the softener dispenser serves this
purpose.
•
Use only the salt, which is intended for dishwashers. Other types of salts, which
are not intended for dishwashers, for example kitchen salt would damage the water
softener. In case of damage caused by the use of the wrong salt, the manufacturer is
not liable for the damages.
• Top up the salt, if possible, immediately before starting one of the complete washing
programs. You will prevent corrosion due to left over salt crystals or overfl owed
solution on the bottom of the dishwasher.
Addition of salt to water softener
The salt dispenser is located under the bottom basket. Fill according to the following
description:
1. Remove the bottom basked and then unscrew and remove the lid of the salt dispenser
1
.
2. If you fi ll the dispenser for the fi rst time, put in 1 kg of salt
2
and fi ll it to the brim with
water
3
. Use a funnel
4
to make adding salt easier. Put back the lid and tighten it.
3. Fill the salt dispenser after about 20 to 30 washing cycles (about 1,5 kg). Fill it with
water only before fi rst use.