ECG EDF 6023 WA++, Instruction Manual

Page: 46 / 124

GB
46
Dishwasher interior
1. Top plate
2. Upper basket with compartments
3. Upper spray arm
4. Bottom basket
5. Bottom spray arm
6. Filters
7. Rating plate
8. Control panel
9. Detergent and rinse aid dispenser
10. Cutlery basket
11. Water softener
12. The running rail of the upper basket
INSTALLATION
INSTRUCTIONS
WARNING!
• Entrust the dishwasher connections for power supply and water supply to qualifi ed professionals.
• The appliance must not stand on the supply or drain hose or on the electrical power cable.
• The dishwasher must be connected to a water supply with a new set of hoses. Do not use an old supply
hose.
Placement of the dishwasher
• Before installation, unpack the dishwasher and dispose of all packaging according to label instructions,
and make sure that there is no damage caused by transportation. If you fi nd any damage, stop the
installation and contact the vendor.
• Do not install the dishwasher in places, where the temperature may dip below 0 °C.
• When choosing a place for the dishwasher, make sure that you can load and unload dishes easily.
• Place the dishwasher close to water supply and drain.
• When moving the dishwasher, do not lift it holding the door or the front panel.
• The dishwasher can also be inserted under your kitchen counter. Be careful when inserting the dishwasher
in place that you do not squeeze the supply and drain hoses. Make sure that the dishwasher is not standing
on the power cable.
• Place the dishwasher on a fl at hard fl oor. Use the adjustable feet to align the dishwasher into a horizontal
position. The level horizontal position ensures greater stability, prevents movement of the appliance and
limits vibration and noise. Correct positioning of the dishwasher will also make the opening and closing
of the door easier.
• If the dishwasher door does not close correctly, make sure the dishwasher is stable and level and if
necessary adjust the level using the adjustable levelling feet.
Connecting the water supply hose
1. The water pressure must be in the range of 0,03 to 1,0 MPa. If the
water pressure is lower, contact a technician.
2. Make sure that the supply hose is not bent or twisted.
3. If the water pipes are new or have not been used for a long time,
have at fi rst fl ow out enough water until completely clean water
comes out.
4. Attach the hose to the water supply and tighten fi ttings.
5. Check the tightness of the connection.
6. Open the water supply tap fully before using the dishwasher.
1
2
3
5
6
7
8
9
10
11
12
4