GB
47
Note:
Some models use a safety hose with Aquastop system, which in case of failure of the appliance or
damage to the hose interrupt the water supply. Never adjust the hose and prevent it being pinched or
broken.
Connecting the drain hose
Connect the drain hose to the drain pipe and make sure that the
hose does not bend or twist. If the drain hose is too short, contact
an authorized service center to request a longer hose of the
same material.
Keep in mind that the hose must not be even
with an extension longer than 4 meters.
A longer drain hose
would prevent proper functioning of the dishwasher. Attach the
hose fi rmly to the drain pipe so that it will not loosen during the
operation of the dishwasher.
Connecting to the sink siphon
The waste connection must be placed at a height of between
50 cm (minimum) and 100 cm (maximum) above the bottom of the dishwasher. The drain hose should be
attached by a clamp. The free end of the hose must not be submerged in water.
Installation of the dishwasher under the kitchen worktop
If you want to put your dishwasher under the worktop, make sure that there is
enough space under the worktop and the layout of the electrical and water lines
permits this installation. If you consider the space under the kitchen worktop
suitable for installation of the dishwasher (see fi g.
1
), remove the top plate of
the dishwasher, see fi g
2
.
Attention:
The space into which you place the dishwasher with top plate
removed should be stable, so that it does not adversely aff ect the
stability of the dishwasher.
To remove the top plate of the dishwasher, remove the screws with which the
plate is attached to the rear wall of the dishwasher. Then push the top plate 1 cm to the back and remove it.
Use the adjustable feet to align the tilt of the fl oor (see fi g.
3
). Insert the dishwasher in the prepared space in
the kitchen worktop. Be careful not to pinch the hose or the power cord.
Attention:
When you remove the top plate, you can place the dishwasher in the space with dimensions
marked in the fi gure
4
.
Power connection
Before connecting the plug of the power cord into an electrical outlet, check the following:
•
The outlet is grounded and complies with current standards.
•
The outlet is suitable for the maximum power of the appliance, which is indicated on the rating plate.
max1
100mm
min500mm
min120mm
min 40mm
m
e
r
move the top plate of
washer with top plate
ot adversely aff ect the
make sure that there is
ectrical and water lines
r the kitchen worktop
move the top plate of
Summary of Contents for EDF 6023 WA++
