![background image](http://html1.mh-extra.com/html/ecg/cd-110-usb/cd-110-usb_instruction-manual_3878575065.webp)
65
EN
Front assembly according to DIN (Method A)
Device installation
1. Metal
band
Remember to use the band to secure the rear part of the device
into place. The band may be bend to a desired angle.
2. Mounting
screw
3. Hex
nut
4. Spring
washer
5. Self-drilling
screw
6. Flat
washer
(a) Dashboard
(b) Bracket
After inserting the holder in the dashboard, select suitable tabs according to the thickness of the dashboard
and bend them to secure the bracket in place.
Removal of the device
Insert both supplied spanners into the grooves on the
left and right side of the device and pull it out of the
dashboard.
Rear assembly according to DIN (Method B)
If you own a Nissan or a Toyota car, proceed
according to following instructions:
Use the screw holes marked T (Toyota) or N
(Nissan) located on both sides of the device and
fasten the device to the mounting bracket, which
is part of your vehicle.
Fastening the device to the mounting bracket:
Align the screw holes in the mounting drawer
with the holes on the device and then secure the
screws to both sides (5x5 mm).
Note:
The outer decorative frame, the bracket
and the metal band are not used when
method B is employed.
a
b
Side view showing the
screw holes marked T,
N or S.
Screw
Dashboard or console
Screw
Radio bracket (part
of the car)