![background image](http://html1.mh-extra.com/html/ecg/cd-110-usb/cd-110-usb_instruction-manual_3878575069.webp)
69
EN
System setup
Press and hold
SEL
button (4) on the control panel to enter the setup mode of the system. Press shortly
SEL
(4) to select the item that you want to change and turn the volume control (4) to change the required setting.
1. TAVOL
Using volume control (4) set the volume for traffi
c reports (TA) when you fi nd the TA station.
2. BEEP
ON/OFF
Using volume control (4) switch on/off audio signals.
3. AREA
EUR/USA
Using volume control (4) set the tuning step AREA EUR or AREA USA.
Note:
The radio frequency bandwidths of Europe and USA diff er.
4. P-VOL
Using volume control (4) select the volume of your device when it is switched on.
Display information
Press
DISP
(6) to switch between display modes.
Setting the time
To show clock on the display, press repeatedly the
DISP
(6) button. Then hold the
DISP
button, until the clock
starts fl ashing. Then press
m
(10) to set minutes and press
M
(1) to set hours.
Equalizer
Press shortly
EQ
(5) to switch on the equalizer function and select the desired audio mode. Five equalizer
settings are available, see below:
FLAT CLASS POP
ROCK
OFF
Muting the sound
Press
1
/MUT
(3) to mute the sound. Press again to renew the original volume.
Loudness
Hold the
BAND/LOU/ENT
(13) button to boost the basses. The display shows “LOUD”. Press and hold again to
switch off this function.
Selection of the display mode and brightness
Press
MODE (DIM)
(8) to set radio, USB, memory card or AUX input.
Hold the
MODE (DIM)
(8) button to change the brightness of the display.
External input
You can connect portable music player to the AUX IN input jack (22) of the device. After connecting the player,
press the
MODE
button (8) to switch the input to AUX.
Reset of the device
Press
Reset
button (23) using a ballpoint pen or other pointed object. Use the
Reset
button in the following
cases:
•
After completing the initial installation of the device and all cabling.
•
When the device does not react to pressing buttons.
•
When the display shows an error symbol.