![background image](http://html1.mh-extra.com/html/ecg/bd-50/bd-50_instruction-manual_3889999036.webp)
36
EN
Battery level (Battery level)
Indicates the state of the batteries in the device. When the battery level
drops to one bar, replace the batteries according to the instructions in
“Battery Installation.”
Indicator of the rinse mode (Rinse)
When you activate the rinse function, the display indicates RINSE and
the device will dispense the liquid from the container for 30 seconds.
You activate the cycle by pressing “+” and “-” buttons in the same time
for 3 seconds. You can stop rinsing by pressing “+” or “-” button.
WALL MOUNT OF THE DEVICE
The dispenser package includes a wall mount bracket. The
bracket can be attached to the wall using either an adhesive
foam pads, or using screws. We recommend using adhesive
foam pads for mounting on ceramic tiles. We recommend
using screws for mounting the bracket on a drywall or wooden
surface, however, it is possible to use the adhesive foam pad
as well.
The installation on a selected location is facilitated by the
included paper template with dimensions corresponding to
the bracket.
Mounting with screws:
Place the template on the location where you want to install the bracket. Mark the position of two holes
for screws. Remove the template and drill two holes of 4,75 mm diameter. Insert screw anchors in the holes
and screw the bracket in place. Set the device on the two protrusions of the bracket and gently push down
to secure the device in the bracket. The device can be easily removed by pushing it up and taking it off the
protrusions of the bracket.
Mounting using foam pad:
Remove the protective paper from one side of the adhesive pad and stick the pad gently to the rectangular
area marked on the back of the bracket. Wipe the wall in the place where you want to install the dispenser
with dry cloth until it is dry and clean. DO NOT ATTEMPT TO INSTALL THE DEVICE IMMEDIATELY AFTER
SHOWERING WHEN THE WALLS ARE NOT PERFECTLY DRY. At the location of the planned installation put
the template to the wall, and carefully remove the protective paper from the other side of the adhesive
pad. Carefully place the bracket into the cut in the template and press fi rmly to the wall. Then remove the
template. Allow the bracket 12 hours to adhere to the wall before inserting the dispenser. Then fi t the device
on the two protrusions of the bracket and push it down gently to secure the device in the bracket. The device
can be easily removed by pushing it up and taking it off the protrusions of the bracket.