11
Firmly connect the cable to the gun with hand. After connecting, lock it using stopper. If the cable is not in
right position, do not connect it forcibly but unscrew the nut so as to bring its hexagonal flat into close
contact with the stopper for proper connection.
Forcible tightening using a tool may damage the cable connector. Do not use an
excessive force. Be sure to lock the connector with stopper.
Secure the connecting cable and air hose at a point 70cm to 80cm away from the gun using insulation
locks. At this time, leave a slack in the connecting cable so as not to apply a load to the connector where it
is connected.
When bundling the cable and air and paint hoses with a tape or the like, leave a
slight slack in the cable so as not to apply a tensile force to the cable. Using
the cable as tensed may cut wires in the cable.
For detail, see 6
“Caution in bundling and handling the connecting cable.”
Connect the other end of the connecting cable to the top of the controller as shown below.
③
Connecting to the air supply.
Connect the air supply to the air hose joint (screw size G 1/4) on the paint pump unit.
Never raise the paint pressure in the paint pump over 21MPa.
Doing so damages the gun or paint may spout out, possibly resulting in injury
or other accidents.
CAUTION
CAUTION
WARNING
