ECCO’s 7965/7970 Series LED beacons are designed to
meet SAE J845 Class I specifications. Available in 5” (7965)
or 7” (7970) height profiles, specifications include 12-24 VDC
operation, 11 flash patterns and a coated aluminum base with 3
bolt mounting flange and an integrated 1” pipe mount. Vacuum-
magnet mounts are also available.
Page 1 of 12
IMPORTANT!
Read all instructions before installing and using. Installer: This manual must be
delivered to the end user.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices are essential to ensure
the safety of you and those you are seeking to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high current arcing,
which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output performance of the
system is maximized and the controls are placed within convenient reach of the operator so that s/he can operate the system without losing
eye contact with the roadway.
5. Do not install this product or route any wires in the deployment area of an air bag. Equipment mounted or located in an air bag deployment
area may reduce the effectiveness of the air bag or become a projectile that could cause serious personal injury or death. Refer to the
vehicle owner’s manual for the air bag deployment area. It is the responsibility of the user/operator to determine a suitable mounting location
ensuring the safety of all passengers inside the vehicle particularly avoiding areas of potential head impact.
6. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the vehicle operator
should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks or compartment doors), people,
vehicles or other obstructions.
7. The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal. Never take the right-
of-way for granted. It is your responsibility to be sure you can proceed safely before entering an intersection, driving against traffic, respond
-
ing at a high rate of speed, or walking on or around traffic lanes.
8. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying all laws regarding
warning signal devices. Therefore, the user should check all applicable city, state, and federal laws and regulations. The manufacturer as-
sumes no liability for any loss resulting from the use of this warning device.
Do not install and/or operate this safety product unless you have read and understand the safety information
contained
Failure to install or use this product according to manufacturer’s recommendations may result in property damage, serious injury, and/or death to
those you are seeking to protect!
!
WARNING!
Specifications:
Size:
7965: 6.0” dia. x 4.8” high
7970: 6.0” dia. x 5.8” high
Weight:
approx. 2 lbs.
Input Voltage: 12-24 VDC system
Input Current:
High intensity mode:
3.6 A @ 12.8 VDC
Maximum power consumption: 36 Watts
Temp. Range: -30°C to +50°C
Figure 1
Installation and Operation Instructions
360° LED Beacon
