4
|
P a g e
E730 Defra instruction manual |
current as of May 2015
All information supplied by
Ecco Stove
TM
is a trade mark of Landy Vent UK Limited copyright©EccoStove2015
Ecco Stove
| Foster House
| 2 Redditch Road,
Studley,
B80 7AX, United Kingdom
T
| +44 (0)1527 857 814
E
W
| www.eccostove.com
Patent pending USA, Canada, Europe & Russia | UK Patent nos: 2467433 & 2498883
IMPORTANT FIRST FIRING MUST BE A LOW INEFFICIENT FIRE FOR THE MINIMUM TWO HOURS TO DRY
THE REFACTORY SILICON CARBIDE SLOWLY: FAILURE TO DO SO WILL CRACK THE APPLIANCE.
PLEASE READ THIS ENTIRE MANUAL BEFORE YOU USE YOUR ROOM HEATER. FAILURE TO FOLLOW
INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH.
1. INTRODUCTION
We would like to thank you for choosing our product and wish you every success and happiness with
your Ecco Wood Burning stove.
Your stove is tested to EN15250 and EN13240 when burning wood logs only. The Ecco Stove has been
recommended as suitable for use in smoke control areas when burning dry wood logs and when a 4mm
permanent gap between the cover and main body of the secondary air cover is in place and when all air
controls are permanently fixed in position.
Please read these instructions. The installation and use of the Ecco Stove is regulated by installation
regulations specific to the country it is to be installed in (building regulations in the UK). The installer
must be aware that all local regulations, including those referring to National and European standards
need to be complied with when installing this appliance.
Not every stove can be connected to every existing chimney. Your installer must check the efficiency
and performance of the chimney to ensure its suitability for us. If the two are not compatible this can
lead to poor burning and blackening of the glass and smoke leakage from the appliance.
The local authority will be able to inform you of the type of fuel you are allowed to burn in the area the
stove is to be installed. Currently the ECCO stove is tested for wood burning but wood maybe burned in
a smokeless designated zone provided it is operated to the following instructions (see Item 12).
Additionally your installer will be able to advise you on the size of stove required for the space you have.
You will need a sufficient flow of oxygen into the room for combustion, which will require a fresh air
vent to be installed into the room where the appliance will stand.
Some of the technical information you or your installer require is included in this handbook. Our
information leaflet and a technical data table are at the rear of the Ecco Stove catalogue for your
guidance.
