Ebyte E180-ZG120A, User Manual

Page: 16 / 44

Chengdu Ebyte Electronic Technology Co.,Ltd. E180-ZG120A User Manual
Copyright ©2012–2019, Chengdu Ebyte Electronic Technology Co.,Ltd.
1
Target network
address
Read/write
0x0000
～
0xFFFF
The current device communication destination (short address) can
be switched at any time through configuration commands;
Local MAC
address
Read 64bitMAC
Module factory MAC address, user can not be changed
Target
MAC
address
Read/Write 64bitMAC
In fixed-point mode, use long address to send;
Device type
Read/Write C
、
R
、
E
、
S
They are: coordinator, router, end-device and sleep end-device;
Channel
Read/Write CH11
～
26
The physical channel through which ZIGBEE works;
Transmit mode Read/Write
0
、
1
、
2
、
3
、
4
、
5
The transmission modes of the configuration module are: broadcast mode,
multicast mode, short address on demand mode, long address on demand
mode, protocol on demand, and protocol multicast. For details, please see
the corresponding mode function introduction;
Output mode Read/Write
0
、
1
、
2
、
3
、
4
、
5
The data output mode is:
Transparent transmission;
Data + short address;
Data + long address;
Data + RSSI;
Data + short a RSSI;
Data + long a RSSI;
Transmitting
power
Read/Write 0
～
20dbm
Module output power: 0 to 20dbm; high power consumption
requirements, where the distance is not required, the transmission
power can be reduced to save average power consumption;
Remote
configuration
ID
Read/Write 2 byte
It is used to determine whether the data received by the air in the
air is a remote configuration command. The customer can change
the unlimited configuration ID according to the requirements. The
default is A8 8A;
Local network
group number
Read/Write 0
～
255
Used to configure the device number of the device in network;
Target network
group number
Read/Write 0
～
255
Group number corresponding to the target when configuring device
multicast;
Wake-up period
(sleep time)
Read/Write 0
～
2010s
It is used to configure the wake-up cycle of the end-device sleep device.
The larger the cycle is, the lower the overall power consumption is, but
the greater the delay of receiving data is;
Network
opening time
Read/Write 10
～
2540s
It is used to configure the opening and closing of network security.
During the opening period, the device can join the network, and during
the closing period, the device cannot join;
Lost parent node
reconnection
period
Read/Write
1
～
255
minutes
When the parent node is lost (the coordinator is powered down), the end-
device reconnects the previous network at regular intervals;
Maximum
number of
reconnections
Read/Write
1 to 255
times
After the parent node is lost, the maximum number of
reconnections, if it has not been reconnected successfully, clears
the previous network information, rescans the new network, and
the scanning period is equal to the reconnection period;
IO state Read/Write High/Low
Access/control module level status of the GPIO channel;