20150330#1.0
EBS Ink Jet Systeme
EN
9
EN
The printer is marked with the following warning label in English, as standard.
The label is put on the left-hand side of the printer on plug
through which electromagnets can be adjusted.
K1
70
117
-0
00
IEC
/E
N
60
82
5-1
:2
00
7
+ A
C1
:20
08
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX OUTPUT: < 1 mW, WAVE LENGTH: 650 nm
Labels in several languages come together with the printer. If you prefer a
different language than English, replace the label with a more suitable one. If
the label is not available in your language, translate the label contents into your
language and hand it over to the printer users.
Protecting the Battery Pack
The following principles need to be obeyed to protect the batteries that are built
into the printer:
Protect the printer against excessive temperature and fire. Do not expose it
to strong solar radiation for a longer time.
Avoid a sudden change in temperature (cold
hot) that might cause vapor
condensation inside the printer and thereby speed up battery discharge
and electronic circuit corrosion. Condition the printer for about 1 hour
before use after it has been moved from a cool place to a warm one.
When Ink or Wash-up Spills
Should the eyes or skin get irritated with ink or wash-up:
!
EYES
rinse the eyes with running water for at least 15 minutes, then
see your oculist.
SKIN
wash the skin with water and soap.
If the clothing has been splashed, take it off as soon as possible.
When ink or wash-up spill, wipe out the spilled fluid with a piece of
absorbent material, and then remove the material in compliance with fire
and health and safety-at-work regulations.