H
oogkamerstraat 188, 9140 Temse Oos-Vlaanderen Belgium +32 470 80 80 83
20
➢
Output Type
MFCTH has 4 types of analog output which you can choose according to your needs. This
change will be applied to both analog outputs the same for temperature and relative
humidity.
0 : 0-10VDC
1 : 0-20mA
2 : 4-20mA
3 : PWM
➢
PID Enable
As a nice feuture of MFCTH it has a PID controller which will make your enviremental
control much smarter and energy efficient. It will also reasult to a smooth changing of
temprature and relative humidity in case if you use analog output to drive your system.
Note: The PID parameters have been set by deffault to the most efficient values for
temperature and Relative humidity control and the parameters will effect the PID result
of both temperature and humidity. To modify the PID values according to your needs and
your envirement you can use
➢
Open Collector Output
The analog output of MFCTH can be set to Open Collector as well in case if needed.
⚠
Attention:
Enable this function if you familiar with the topic or ask your expert if it
needed to be enabled for your installation.
➢
Reset
It’s always possible to reset all your configurations. By resetting your controller
all
Modbus Holding registers will be back to their default value (including device ID).
⚠
Attention:
Resetting the device will set the device ID to the default value
which is 1 and that may cause communication issues in case you have a device
with same ID (1) on your network.
➢
Standby
Setting your controller to stand by mode will disable all outputs. It will be useful in case
of holding the control on your environmental condition like maintaining your installation
etc.
MODBUS REMOTE CONTROLLING/MONITORING APPLICTION (EBICON)
As a very important part of our solutions to control your environmental condition we provide you
a free of charge software (Ebicon) developed to monitor and control(configure) your controller
’
s
