H
oogkamerstraat 188, 9140 Temse Oos-Vlaanderen Belgium +32 470 80 80 83
18
output value(A2) accordingly and depending on the setting for humidifying or
dehumidifying mode.
➢
Heat/Cool Mode
The controller can be set to two different mode to controll the temperature:
1.
Heat Mode: means your enviremet soppused to get heated and by default it
gets cold. So, the controller needs to try to heat it up to the desired
temperature set point as it goes below the set point.
2.
Cool Mode: means your enviremet soppused to get coled down and by default
it gets warm. So, the controller needs to try to cool it down to the desired
temperature set point as it goes above the set point.
➢
Humidifying/Dehumidifying mode
The controller can be set to two different mode to controll the relative humidity:
1.
Humidifying
Mode: means your enviremet soppused to get humid and by
default it gets dry. So, the controller needs to try to humidify it up to the
desired humidity set point as it goes below the set point.
2.
Dehumidifying
Mode: means your enviremet soppused to dehumidified and by
default it gets humid. So, the controller needs to try to dehumidfy to the
desired hemid set point as it goes above the set point.
➢
Use Multiple sensors
It’s possible to connect and read multiple sensors
(up to 8) to the controller to get average
of measured temperature and relative humidity in case if needed.
⚠
Attention:
•
To use this function you need an extra device called SM8 which you
can
find
in
the
list
of
our
products|accessories.(see
•
In case if using this feuture please make sure your multiple
sensors(at least 2) are connected to the SM8 and the SM8 is
connected to the MFCTH controller according to the wiring
diagram of the devices(please refer to the datasheet of SM8 for
connecting the sensors and wiring).
•
Enabling this function without connecting multi sensors will causing
errors in communication with the sensor and misbehave of the
controller.
