IXU 2000
EN
12
13
5. REMOTE CONTROL
6. CLEANING AND MAINTENANCE
DEVICE CONTROL
CLEANING
The remote control allows the user to change of the current operating mode.
There are three modes available.
The current operating status is indicated by the LED on the left side of the device.
The green LED indicates the work of the device. After connecting the device to
the power supply and turning the main power switch to position I, the device is in
the standby mode. The LED flashes red. Press the ON / OFF button on the remote
control. The LED is green, the device is turned on, but not working yet. Press an
appropriate button (750W, 1500W, 2000W) to start the desired operating mode.
It is not possible to change the operating mode without the remote control. The
constant access to the remote control should be provided.
Note! The device should be inspected and cleaned regularly to ensure long and efficient operation. In case
of working in a highly polluted environment (e.g. with increased dustiness), the number of inspections
should be increased.
In order to properly check the condition of the device:
•
Check for visual deformations. In case of noticing any deformation, consult the producer or a
qualified service center.
•
Visually check the condition of the power cord and plug. In case of noticing any deformation, consult
the producer or a qualified service center. Do not use the device with a damaged cord or plug.
•
Before cleaning the device, switch it off using the main button and disconnect it from the power
supply. Make sure to hold the plug, not the cord, while disconnecting from the power socket.
•
After switching off the device, wait until all parts of the device cool down. Danger of burns!
•
Do not open the device by yourself. Repairs requiring opening the housing may only be performed
by the manufacturer or a qualified service center!
•
Do not submerge the device in water. Do not pour water or other liquids over the device.
•
Do not use strong chemical cleaning agents, solvents or alcohol for cleaning. Risk of damaging the
device components!
•
Device should be cleaned with a soft, damp cloth and left to dry.
•
Clean the heating rods with a long soft brush.
•
Compressed air can be used to clean the inside of the device from dust and dirt.