Eberg AORI E25-09, Instruction Manual, Page: 61 / 76

AORI EN
61 www.eberg.eu
INSTALLATION OF OUTDOOR UNIT
STEP 1: FIX THE SUPPORT OF OUTDOOR
Select it according to the actual installation situation
1. Select installation location according to the house structure.
2. Fix the support of outdoor unit on the selected location with expansion screws.
Note:
• Take sufficient protecttive measures when installing the outdoor unit.
• Make sure the support can withstand at least four times of the unit weight.
• The outdoor unit should be installed at least 3cm above the the floor in order to install drain joint.
• For the unit with cooling capacity of 2300W~5000W,
6 expansion screws are needed
STEP 2: Install drain joint and chasis rubber plug
1. Connect the outdoor drain joint into the hole on the
chassis, as shown in the picture below.
2. Connect the drain hose into the drain vent.
3. For chasis eletric heater equiped unit, there are
several drain holes on the chasis, which is used for
quick drainage to avoid chasis freeze in cold area.
If there is no need for quick drainage, please fix the
rubber plug into chasis. According to drain hole
shape, select corresponding plug to fix into holes
from the bottom, shown as the left.
Note!
There is no drain joint and chasis rubber plug for some
unit, please refer to accessary package.