22
XSTORAGE HOME 3P INSTALLATION MANUAL
MN700009EN August 2020 www.eaton.com
00 Title
Improper or unauthorized use:
Although carefully constructed, all electrical appliances can catch fire.
The xStorage Home 3P system is intended for indoor installation.
Optimal operation of the xStorage Home 3P system is ensured at a maximum ambient temperature of
40 °C (104 °F).
The xStorage Home 3P system must be transported and stored in indoor locations with a temperature range of
-30 °C to +70 °C (-22 °F and 158 °F).
The xStorage Home 3P system must be used in locations with no acids, gases or other corrosive substances.
The xStorage Home 3P system must be used and stored in locations with relative humidity ranging from 5 % to
95 % without condensation.
The xStorage Home 3P system must be transported in locations with relative humidity ranging from 5 % to 95 %.
The xStorage Home 3P system must be used and stored in locations with atmospheric pressure ranging from 86
kPa to 106 kPa.
The xStorage Home 3P system must be transported in locations with atmospheric pressure ranging from 70 kPa
to 106 kPa.
The xStorage Home 3P system must be used at a maximum altitude above sea level of 3000 m (9750 feet). For
altitudes above 2000 m, due to the rarefaction of the air, specific conditions may occur which must be considered
when choosing the place of installation. All installations at altitudes above 2000 m must be assessed case by
case considering the following critical issues:
•
Less efficient cooling.
•
Decrease in the dielectric strength of the air and, in the presence of high voltages, the creation of electric arcs.
•
Presence of cosmic radiation that can affect the correct functioning of the electronic components.
•
The operators must be correctly informed. The operators must therefore read and follow the
technical instructions contained in the manual and in the enclosed documentation.
•
The instructions provided in this manual do not replace the safety regulations and the installation
and operational technical data printed on the products, nor do they replace the current safety
standards enforced in the country where the equipment is installed, and the rules dictated by
common sense.
•
The manufacturer is available to provide the theoretical or practical training to operators, both on
their site or on the customer’s premises, as specified at the time of drawing up the contract.
•
The equipment must not be used if any operating fault is identified.
•
Temporary repairs should be avoided; repair work must be carried out only with genuine spare
parts, which must be installed according to the intended use.
•
The responsibilities deriving from the commercial components are delegated to the respective
manufacturers.
Avoid touching the inverter enclosure during the equipment operation.
The hybrid inverter enclosure could overheat during its operation and cause burns by contact.
3.2 Suggested protections during the installation
The equipment was built according to the highest level of safety standards and equipped with safety devices
suitable for the protection of operators and components.
For obvious reasons, the manufacturer cannot envisage all potential type of installations and locations where
the equipment will be installed; the customer must therefore clearly inform the manufacturer of specific
conditions of installation. Eaton declines any responsibility if the xStorage Home 3P system is incorrectly
installed and shall not be liable for other systems located upstream or downstream of the equipment supplied.
