Installation
44
Powerware
®
Prestige Series Installation and Operator’s Manual for IBM Applications (650 VA - 1500 VA)
Uncontrolled Copy
8.
Verify the Bypass switch on the PPDM rear panel is in the
NORMAL position.
9.
Plug the Y-cord into the power connectors on the UPS as shown
in Figure 8 and Figure 9.
10.
The equipment to be protected by the UPS should be powered
off. Plug the equipment into the power output receptacles on
the PPDM rear panel.
NOTES
:
Use the IEC 320-C19/C20 output cord provided with the PPDM to connect the
AS/400 to the PPDM.
:
You may have to use the output cord provided with the PPDM for 230V usage.
:
The AS/400 line cord must be used from the PPDM input connector to the wall
outlet (see Step 3 on page 46).
:
When using the PPDM, it is recommended that the equipment not be plugged
into the UPS cabinet.
:
Do not protect laser printers with the UPS/PPDM because of the exceptionally
high cyclic power requirements of the heating elements.
11.
For the AS/400 interface, plug the AS/400 communications
cable into the serial port on the UPS rear panel. Plug the other
end of the cable into the connector, located on the back of the
system unit, labeled “UPS” (AS/400 Models 600 and S10).
12.
If your PPDM is a 120V unit, see the following section, “UPS
with PPDM Startup for 120V Models.” If your PPDM is a
208V-240V unit, skip to “UPS with PPDM Startup for
208V-240V Models” on page 47.
