4
EATON
IL520003EN
Installation Instructions
Installation Instructions - LDSQA4 Commercial Recessed Adjustable LED
BLACK
LINE
WHITE
NEUTRAL
GROUND
GREEN/BARE COPPER
Figure 13.
Cleaning
To Clean Trims:
1. Gently wipe with soft, clean, dry lint free cloth to
remove dust.
2. Wipe with mild detergent solution on a soft, clean cloth
to remove fingerprints and stains.
3. Rinse with clean water and dry with soft, clean, dry
lint free cloth.
Thumb
Screw
Access
Plate
Junction
Box
Latch
Driver
Assembly
Figure 14.
Figure 15.
Electrical Connection
CAUTION
Make certain no bare wires are exposed outside of wire nut
connectors.
1. Provide electrical service according to the “National
Electrical Code” or your local electrical code to the
junction box (located on the plaster frame). Supply wire
insulation must be rated for at least 90°C. The junction
box is rated for a maximum of 4 No. 12 AWG Branch
Circuit conductors that must also be suitable for at
least 90°C.
2. Remove junction box cover (Figure 13).
2. Remove appropriate round pry out and connect conduit
to junction box with proper connector (not included).
3. Connect supply lead wires to junction box lead wires
(line, neutral and ground) in the fixture using properly
sized wire nuts. Be careful not to leave any bare
conductors outside of the wire nut connectors.
4. Connect white wire to neutral, black wire to supply line,
and ground (from electrical service) on the supply side
to the bare copper wire in the junction box. See wiring
diagrams for low voltage wire connections. Place all
excess wiring and connections into the junction box
and replace the cover.
Driver Replacement
CAUTION
To avoid possible electrical shock, be sure that the power is
turned off before installing or servicing this fixture
The driver should be replaced by a qualified electrician.
The driver may be replaced either from below or above the
ceiling.
1. If below the ceiling remove trim assembly from
housing then loosen Thumb Screw, rotate Access Plate
clockwise slightly and pull in to remove (Figure 14).
2. Push Junction Box Latch outward to remove Driver
Assembly (Figure 15).
3. Disconnect wiring to Driver Assembly by removing wire
nuts.
4. Discard old Driver Assembly.
5. Connect new driver leads with wire nuts.
6. Reattach new Driver Assembly and latch securely.
