EATON ELECTRICAL
45
Predictive Diagnostics
5 Appendix 1. Device Setup via Keypad
The following description follows the sequence of setup options that appears while using the RIGHT
ARROW key. If the left arrow is used the sequence will opposite.
Entering Setup Mode:
Press “
Set
” key.
PSd-____
will appear on the display. A correct password must be entered, in order
to enter the setup mode. Using
keys, enter password and press
ENTER
. Wait
approximately 20sec. The first option to appear is the date/time setup. Use the right and left arrow
keys (
) to scroll the setup parameters.
Date:
Setting the current date.
Scroll setup parameters until
d-XX.XX.XX
appears.
Press
Enter
. Active digits will start flashing. Use
keys to select the desired numeral. Use
keys to activate the next (previous) segment of the display.
When done, press
Enter
.
Note:
In the firmware versions 2.0 and later, IG performs check on data preexisting in the device memory.
If DATE that is set is earlier then preexisting data IG will prompt for clearing data that is later that date is
set.
The prompt is
EditArCH
If Enter is pressed all later data will be erased, if Cancel is pressed new date will
be set without data erasing and then in normal mode
CLOCHErr
will be displayed.
Time:
Setting the current time
Scroll setup parameters until
t-XX.XX.XX
appears.
Press
Enter
. Active digits will start flashing. Use
keys to select the desired numeral. Use
keys to activate the next (previous) segment of the display.
When done, press
Enter
.
Activate Channels:
The device has 15 signal channels. Depending upon application, some channels can be used while the
rest remain inactive. Do not activate more channels then necessary. This will conserve data memory.
Scroll setup parameters until
CHAnnELS
appears.
Press
Enter
.
CH01-On(OFF)
will appear. Use
keys to set the channel to On or Off. Use
keys to scroll the channels.
When done, press
Enter
.
Next,
nCH
will appear. Use
keys to set the noise channel to On or Off.
When done, press
Enter
.
Parameters to Display:
Several parameters are available to display:
Date - (
dAtE
)
Time - (
timE
)
Time of next measurement - (
rEAd
)
Scroll channels - (
CHAn
) (This option will scroll data for all active channels in terms of % of Red threshold
and Alarm status.)
Power Frequency - (
FrEQ
)
Temperature - (
Fr06
)
Voltage - (
Fr07
)