Settings Options and Partitions Menus
Page 82
Press the Menu key to gain access to the setting menu to set another partition that
is not involved in the current setting event. Note that if the user is allocated to a
single partition, that partition may start setting immediately.
If the calendar set warning timer has been deferred by a user, the control unit halts the
warning timer, and defers any consequent setting event for 30 minutes. At the
programmed warning time, the control unit starts counting down the warning timer again.
Users can defer a calendar set in this way a total of three times. After the third deferral, the
control unit sets the system.
Note that deferring setting does not defer any unsetting events.
Setting Faults
If there is a fault that would normally prevent the system from setting, a calendar set event
will also fail. Before the time of a setting event, the control unit starts the calendar set
warning tone as usual, but at the setting time, the control unit will not set the system. The
control unit will log the failure as “set fail”. At the same time, the control unit will activate
any output programmed as type Set Fail.
Note that if you assign zones the Force Set Omit attribute, the control unit will omit those
zones if they are active during a scheduled setting event.
