System Options Menu
Page 92
Restore Defaults
Staged Defaults
This menu option allows you to default parts of
the control unit’s configuration without
affecting the whole system. You can choose to default the following:
User
Defaults all user access codes, their HUAs, proximity reader tags, and remote
controls. User 001 access code changes to 1234 or 123456, as applicable.
This option also allows you to change between 4-digit and 6-digit codes. If you
change to 6-digit codes, two additional zeros are added to the end of the existing
installer code. If you change to 4-digit codes, the final two digits are removed from
the end of the existing installer code.
Note:
If you wish to make the i-rk01 use four-digit or six-digit access codes, please
refer to the i-rk01 installation instructions.
Zones
Defaults all information relating to zones: types, attributes and partitions. For radio
zones, the control unit retains the IDs of any detectors that the control unit has
already learned.
Radio Devices
Deletes the IDs for learned radio devices. Scroll through the list of devices and select
Yes for each type you want to delete, then press
to action your selection. The
Keypads
option deletes one-way radio keypads only.
Outputs
Defaults all output configuration.
Setting Information
Defaults all setting options.
System Options
Defaults all options in the
System Options
menu.
Communications
Defaults all configuration for communications.
Factory Defaults
Tis removes all configuration from a control unit, including all names and stored texts, but
not the log.
Note:
You may wish to make a backup of the configuration before using
Factory Defaults
.
You can do this using the Downloader software or the web interface.
To use the option:
1.
Select
Factory Defaults
and confirm the operation when prompted.
2.
Answer the configuration prompts. These are similar to those displayed when you
first powered-up the control unit (see page 20).
3.
To delete all users, remove and reconnect all power to the control unit immediately
after using
Factory Defaults
(before you exit the Installer menu). You will need to
repeat step 2 when you re-apply power.
4.
Exit the Installer menu. The system scans the bus and finds the devices (see page
51).
