i-on160EX
Installation
Page 17
system.
3. Open the keypad tamper.
4. Press and hold down B and
together for at
least two seconds.
The keypad is now in local
programming mode,
the display shows the
current status.
MENU
ABCD
To Switch ABCD LEDs ON or OFF
1. Enter local programming
mode (see above).
MENU
ABCD
2. Press
or
to enable or
disable the ABCD LEDs.
The character at the right of
the display shows “
” when
the LEDs are disabled and
“
” when the
LEDs are enabled. For
example:
MENU
ABCD
3. Leave local programming
mode and save your
changes (see page 17).
To Change Backlight Settings
1. Enter Local Programming
mode (see above)
MENU
ABCD
2. Press
. The display shows
the current status of the
backlight LEDs, for
example:
MENU
BACKLIGHT
3. Press
repeatedly to select
one of the following:
Backlight LEDs ON (
).
MENU
BACKLIGHT
Backlight timed (
).
The backlight will glow for
12 seconds after the last
keypress. The action of
the backlight depends on
the programming of the
control unit (which must
have Release 3 or later
software installed).
MENU
BACKLIGHT
4. Leave local programming
mode and save your
changes (see below).
To Disable/Enable the Status OK LED
1. Enter Local Programming
mode.
MENU
ABCD
2. Press
repeatedly until
the display shows:
MENU
STATUS OK LED
3. Press
repeatedly to
select one of the
following:
Status OK LED ON (
).
MENU
STATUS OK LED
Status OK LED OFF (
).
The green status LED
under the navigation key
will glow for 20 seconds
after the last press (this
may be useful when the
keypad is placed in
bedrooms that should be
completely dark at night).
MENU
STATUS OK LED
4. Leave local programming
mode and save your
changes.
To Disable/Enable the Status Fault
LED
1. Enter Local Programming
mode.
MENU
ABCD
2. Press
repeatedly until
the display shows:
MENU
STATUS FLT LED
3. Press
repeatedly to
select one of the
following:
Status Fault LED ON (
).
MENU
STATUS FLT LED
Status Fault LED OFF
(
).
The red Fault LED under
the navigation key is
disabled, and will not
glow for any fault reports.
MENU
STATUS FLT LED
4. Leave local programming
mode and save your
changes (see below).
To Leave Local Programming Mode
and Save Changes
EITHER:
Press
OR
Close the keypad tamper.
The keypad saves the changes you have made in
its local memory.
You can now remove 12Vdc power, if required, or
leave Installer Menu on the control unit.
