User Menu Options
Page 51
To edit an output:
1.
Select
System Config
– Edit Outputs
.
The first output you are able to edit is displayed:
The top line shows the address and type of the output. In the above
example, the address is PAN>01 and the type is W (wired). The
output type is displayed for control units that have built-in radio and
wired outputs. The bottom line shows the name of the output.
2.
Press
or
followed by
to select the output you want to edit.
3.
Press
or
followed by
to select the setting to change:
Name
You can edit the name of the output. See page 27 for
details of how to enter text.
Latched
Use
or
followed by
to select Yes or No. When set
to No, the output changes state when activated, but then
returns to the normal state again after the period specified
by
On Time
(see below). When set to Yes, the output
changes state every time a user operates the output, or
according to a schedule if you specify
On Time
,
Off Time
and
Days
(see below).
On Time/Off Time/Days
If Latched is set to No, use
On Time
to specify the number
of seconds you want the output to remain active. If you
specify zero seconds, the output will not operate.
You can use
On Time
,
Off Time
and
Days
to specify a
schedule for the output to activate and deactivate
automatically. Use
On Time
and
Off Time
to specify the
time you want the output to activate and deactivate. Use
Days
to specify the days of the week you want the output to
operate (use
or
to display each day, then
or
to
choose Yes or No).
Note:
If a user activates the output while it is deactivated,
the output stays activated until the control unit reaches the
next off time. If a user de-activates the output while it is
activated, the output deactivates until the control unit
reaches the next on time.
