User Menu Options
Page 49
Edit Exception
Use
System Config
– Calendar Set – Edit Exception
to edit individual parts
of an exception.
Delete Exception
Use
System Config
– Calendar Set – Delete Exception
to delete an
exception.
Deferring calendar setting
During the calendar set warning time, a user can interrupt the setting
process. To do this, the user must enter the access code at a keypad that
has a display (or present a prox tag), then do one of the following:
Press
or
to see details of which partitions or part of the
system is about to set.
Press
to allow the setting event to proceed.
Press
to defer setting for 30 minutes. Note that for a partitioned
system, the user must belong to the partition that is due to be set.
Press the
key to gain access to the setting menu to set another
partition that is not involved in the current setting event. Note that if
the user is allocated to a single partition, that partition may start
setting immediately.
If a user defers a setting event, the control unit halts the warning timer, and
defers setting 30 minutes from the start of the warning time. At that time,
the control unit starts counting down the warning timer again. The user can
defer setting in this way a total of three times. After the third deferral, the
control unit sets the system.
Note that deferring setting does not defer any unsetting events.
Setting faults
If there is a fault that would normally prevent the system from setting, a
calendar set event will also fail. Before the time of a setting event, the
control unit starts the calendar set warning tone as usual, but at the setting
time, the control unit will not set the system. The control unit will log the
failure as “set fail”. At the same time, the control unit will activate any output
programmed as type Set Fail.
Note that if an installer assigns zones the Force Set Omit attribute, the
control unit will omit those zones if they are active during a scheduled
setting event.
