Setting and Unsetting
Page 13
The installer can use a
2W Set Instant
option to choose whether the remote
control should set instantly or follow the configured exit mode (such as a
timed set).
Operating the buttons
To ensure that the remote control does not accidentally operate while it is
in your pocket, the buttons are deliberately slow to respond to pressure.
You must hold down the button you intend to press for at least three
seconds to activate its function.
See page 52 for details of programming the * button.
Setting from a two-way remote control
1.
Make sure the system is in standby.
2.
Press and hold the Set or Part Set button, as required. The Set or Part
Set LED flashes red three times.
If there is a fault (for example a zone is active), all four LEDs glow red
for three seconds.
3.
You will hear a continuous exit tone (unless the system is configured
for silent or instant setting). The system sets as described in step 6 on
page 9.
4.
The Set or Part Set LED glows green for three seconds. This is your
confirmation that the control unit has set the system.
Unsetting from a two-way remote control
Note:
The ability for remote controls to unset the system can be disabled
(see page 56).
To unset the system:
1.
Enter through the entry route designated by the installer.
2.
Depending on how the system is configured, you may hear an entry
tone. If you hear the tone, you will have limited time to unset the
system before it generates an alarm.
3.
Press and hold the Unset button. The Unset LED flashes red three
times.
4.
The Unset LED glows green for three seconds. This is your
confirmation that the control unit has unset the system.
