Eaton FERRUPS Rack Mount UPS (850 VA–7 kVA) Installation Guide
S
164201425 Rev 1
www.eaton.com/powerquality
1
Chapter 1
Introduction
The Eaton
®
FERRUPS
®
Rack Mount uninterruptible power system (UPS)
is available in plug-receptacle or hardwired models. The plug-receptacle
models have an input plug and receptacles on the rear panel. The
hardwired models have terminal strips that an electrician has to wire to
AC input.
See the following sections for steps on how to use this manual for your
UPS installation.
Plug-Receptacle Installation
Only a few sections in this manual are required for installing
plug-receptacle models:
S
Be sure to read all safety warnings before installing the UPS as stated
in Chapter 2, “Safety Warnings.”
S
Complete Chapter 3, “Setup” for setting up the location of the UPS.
S
If you purchased an external battery cabinet, an electrician must
install the battery cabinets as described in Chapter 4, “Battery
Cabinet Installation.”
S
Install the UPS cabinet as described in Chapter 5, “UPS Cabinet
Installation.”
S
If you purchased an external battery cabinet, an electrician must
complete the DC wiring as described in Chapter 7, “Battery Wiring.”
S
Continue to the startup section in the
Eaton FERRUPS Rack Mount
UPS (850 VA–7 kVA) User's Guide
.
Hardwired Installation
Most of the sections in this manual are required for the electrician to
install the hardwired models:
S
Be sure to read all safety warnings before installing the UPS as stated
in Chapter 2, “Safety Warnings.”
S
Complete Chapter 3, “Setup” for setting up the location of the UPS.
Summary of Contents for FERRUPS
Page 1: ...Powerware Series Eaton FERRUPS Rack Mount UPS Installation Guide...
Page 83: ......
Page 84: ...1642014251 164201425 1 80 z z...
