9
EATON
IB528001EN
Installation instructions
Installation Instructions - Arena Series
●
●
AIRBURST CONTROLSe:
Using an RDM controller, program the DMX start channel(s) for the luminaire’s wireless controller
card. See the table below for a breakdown of controller card personality by model series. This takes 3 main steps, unless
otherwise noted:
1. Set the luminaire DMX start channel
2. The personality setting sets the footprint. Verify the personality is correct (see chart below).
3. Set the show id to match the transmitter show id
4. If desired, label the luminaire to identify it easier during scene programming
otee:
N
In order to use Airburst controls, you must be using a City Theatrical Transceiver and the show ID must be set to the
same channel as the show ID on the fixtures.
Default channels unless otherwise noted
Light Series Personality
Channel Assignment
Arena Pro
2 Channel
Channel 1
Warm LEDs
Channel 2
Cool LEDs
Arena
1 Channel
Channel 1
All LEDs
Prism
3 Channel
Channel 1
Red LEDs
Channel 2
Green LEDs
Channel 3
Blue LEDs
●
●
AIRMESH CONTROLSe:
With Airmesh controls, Ephesus will provide the Bluetooth program to connect wirelessly. Simply
open the provided application and connect to each fixture through Bluetooth recognition. Refer to the Airmesh control
manual provided for more information regarding the mesh network controls.
There are no physical control connections necessary for wireless controls.
Step 4 – Aim The Luminaires
Aiming the luminaires is a critical part of the LED lighting solution to ensure that light is evenly distributed on the playing
surface. There are two basic methods to properly aim a sports venue – Precision Laser Aiming by Coordinates, and Orient
Tilt.
Precision Laser Aiming by Coordinates
Laser aiming is the most effective and preferred technique for aiming Ephesus LED sports lighting. This method uses a laser
mounted to the luminaire to point the Luminaire at a predetermined point on the playing surface using (X,Y) coordinates,
provided with the installation photometric drawings.
otee:
N
Unless otherwise noted, aiming coordinates on Ephesus photometric or project Installation drawings are based on the
origin (0, 0, 0) placed at center field, court, or ice. For baseball fields, origin is usually the back point of home plate. All
dimensions from that point are in feet along the playing surface unless otherwise noted.
Orient –tilt
With the Orient-Tilt method, the installer turns the luminaire according to predetermined angles. This technique is extremely
helpful for pre-aiming Luminaires mounted on a cross arm on the ground before the lighting pole is lifted up and set in place.
However, this method is less accurate due to the variances in actual final structure and luminaire locations and orientations
compared to the approximated parameters used in the photometric design.
Orient Angle:
Refers to the direction the luminaire faces in the Z-plane. In other words, mount the luminaire to the structure but leave the
mounting nut slightly loosened to allow the entire Luminaire to spin about the mounting bolt. Set the luminaire Orient by
rotating the luminaire mounting bracket relative to the mounting structure.
