11
EATON
IB528001EN
Installation instructions
Installation Instructions - Arena Series
WARNING
NEVER use any power tools on the Luminaire while the power is on. The vibration caused by power tools may
damage the Luminaire. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE AND
FAILURE.
otee:
N
For outdoor daytime aiming when the laser dot is difficult to see, a piece of rigid tubing may be used in place of the
laser. Outside diameter of tube must be 0.8”-0.87” (ANSI NPS ½”) to fit into the Aiming Mount. Slightly smaller
conduit such as ½” EMT may be used in the mount with a grommet or other shim only if the shim is evenly
distributed around the tubing to keep it correctly aligned perpendicular to the front face plates of the luminaire.
WARNING
NEVER point the aiming laser at any person or animal as it can cause permanent damage to eyes. Use laser only for
aiming Luminaires as directed. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO SEVERE INJURY.
otee:
N
Turn off laser while not in use to conserve battery life. Have a spare battery charged to facilitate the aiming process.
Laser Aiming Instructions
Equipment Required:
●
●
Tape Measures or Digital Range Finder
●
●
Paper Plates
●
●
Spare batteries for Laser or charger if needed
●
●
Laser or Aiming Tube
●
●
Aiming Mount
●
●
1 5/16” Socket Wrench or impact driver (For hex nuts on center stud mounts, Orient aiming)
●
●
3/8” Hex driver (For allen bolt, Tilt aiming)
●
●
Torque wrench/driver
PROCEDURE:
1. Slide the laser into the Mount, with the on/off button at the top and the laser end directed out toward the end with the
U-shaped flange. The laser does not need to fit all the way in – it’s designed to interfere as it is pressed in, about halfway
down is sufficient.
otee:
N
It may be necessary to file off the knurled section of the laser if it doesn’t fit properly in the Mount, as shown. This
can be done with a metal file and won’t damage the laser.
2. For each light, insert the Mount into the back of the light Luminaire between the two heat sinks near the center, as
shown on the right. If necessary, gently rock the Mount back and forth until it fully seats into place.
Position the Mount to either side of the gap in the fins, this will allow the fins to help hold the mount in place. If the fit
is too tight, do not force the Mount to snap in – just press in gently and align it perpendicular to the face of the light. If
the fit is too loose and the Mount wobbles, hold it in place during aiming by pressing down. This will hold it flat against
the fins and ensure alignment.
