46
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Rear Bearing Cover Removal
|
Removal
TRSM0950
Procedure – Removal
1.
Perform “Oil Drain Procedure” on page 7.
2.
Perform “Output Yoke Removal” on page 43.
3.
Remove the 8 Rear Bearing Cover 13 mm Cap Screws.
4.
Using a pry bar, separate the Rear Bearing Cover from
the rear housing.
Note:
Two pry points located at 12 and 6 o’clock.
5.
Remove the Rear Bearing Cover, Wear Sleeve and Dust
Cover.
NOTICE:
If replacing the Output Seal, a new Rear Bear-
ing Cover is required when reinstalling or an oil leak
may occur.
6.
Remove the O-ring.
Summary of Contents for Endurant
Page 1: ...Service Manual Endurant 12 Speed Automated Transmission TRSM0950 EN US March 2019 ...
Page 2: ......
Page 247: ......
