2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
139
TRSM0950
Installation
|
Rear Bearing Cover Installation
5.
Apply Gasket Sealant to the rear housing as shown in
the pattern below.
NOTICE:
Ensure there is nothing in the threaded bolt
holes or the transmission may be damaged when cap
screws are tightened.
6.
Slide the Rear Bearing Cover over the output shaft.
Note:
Align the two pry points at 12 and 6 o’clock posi-
tions.
7.
Install 8 Rear Bearing Cover 13 mm Cap Screws and
torque to 21-25 Nm (16-19 lb-ft) in a criss-cross pat-
tern.
8.
Slide the Wear Sleeve and Dust Cover over the output
shaft.
9.
Perform “Oil Fill Procedure” on page 213.
Summary of Contents for Endurant
Page 1: ...Service Manual Endurant 12 Speed Automated Transmission TRSM0950 EN US March 2019 ...
Page 2: ......
Page 247: ......