186
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Main Housing Installation
|
Installation
TRSM0950
Procedure - Installation
1.
Clean the sealing surfaces on the Clutch Housing and
Main Housing with Gasket Remover.
NOTICE:
Do not use abrasive scrapers or powered
tools to clean sealing surfaces or sealing surfaces may
be damaged and leak.
2.
Inspect threaded bolt holes for debris and clean if nec-
essary.
NOTICE:
Ensure there is nothing in the threaded bolt
holes or the transmission may be damaged when cap
screws are tightened.
3.
Slide O-ring over the Clutch Housing Inertia Brake air
passage alignment pin until fully seated in groove.
4.
Apply Gasket Sealant to clutch housing as shown in
pattern below.
NOTICE:
Ensure there is nothing in the threaded bolt
holes or the transmission may be damaged when cap
screws are tightened.
5.
Install Lower Countershaft Pilot Tool (RR1071TR) onto
Lower Countershaft above rear bearing race.
Summary of Contents for Endurant
Page 1: ...Service Manual Endurant 12 Speed Automated Transmission TRSM0950 EN US March 2019 ...
Page 2: ......
Page 247: ......