Exercise 1: Ladder Logic Programming
Now that the program is downloaded…
Intro:
Preface
•
To put the ELC in RUN mode, click on the green RUN button in the toolbar or choose
COMMUNICATION>RUN from the menu.
•
To monitor the Ladder Logic, click the Ladder Start Monitoring button in the toolbar
(there are popup tips that tell you what each button does when you mouse over
them), or choose COMMUNICATION>LADDER START MONITORING.
Support
Services
Exercise 2: Logic
Instructions
Exercise 1:
Ladder Logic
Connecting to
the ELC
Software
Overview
Hardware
Overview
Basics:
Exercises:
Go Chart
•
Once you are monitoring the ladder, you can select a contact and right click to
change its state (see below).
•
Note the status line at the bottom of the program that shows the info on current
programming mode (Replace or Insert), selected cell, scan time, number of steps
used/total capacity, communication indicator (blinking when comms are present),
ELC state, which port you’re connected to, baud rate, and ELC processor type.
Exercise 1:
Ladder Logic
Exercise 2:
Logic
Instructions
Pub. No. TR05003001E
For more information visit:
www.EatonElectrical.com
18
