Eaton 9PX 1000i, Installation And User Manual

Page: 85 / 96

6.5
UPS Replacement - HotSwap MBP module configured
The HotSwap MBP module
enables UPS servicing or even
replacement without powering off
the load.
Maintenance
1. Set the switch to the
"Bypass" position. The red LED
indicator
on the HotSwap
MBP lights up, indicating that the
load is directly powered by the
AC input power supply.
2. Press the "On/Off" button
on the UPS control panel to
power off the UPS. The "UPS
ON
– OK to switch" LED
indicator goes off and the
UPS can be disconnected and
replaced.
Return to normal operation
1. Check whether the UPS is
correctly connected to the
HotSwap MBP.
2. Press the "On/Off" button
on the UPS control panel to
start the UPS. The "UPS ON
–
OK to switch" LED indicator
on the HotSwap MBP will light up
(otherwise it means a connection
error between the HotSwap MBP
and the UPS).
3. Set the switch to the
normal position. The red LED
indicator on the HotSwap MBP
goes off.
6.6 Old Equipment Recycling
For more information about proper disposal of old equipment, please contact your local recycling or
hazardous waste center.
•
Do not throw the battery into a fire, as it may explode. Please dispose of used batteries properly. Refer
to your local regulations for disposal requirements.
•
Do not disassemble the battery. The released electrolyte is harmful to skin and eyes and may be toxic.
Do not dispose of the UPS or batteries in the trash. This product contains sealed lead-acid batteries that must
be disposed of properly. For more information, please contact your local resource recycling/reuse or
hazardous waste disposal center.
Do not discard waste electrical or electronic equipment (WEEE) in the trash. Please contact your local
resource recycling/reuse or hazardous waste disposal center for proper treatment.
Load