EN
EN-17
Release the button and check whether the wheel is secured by pulling it. Repeat
this process on the opposite side with the other rear wheel.
To remove the rear wheel, press the button in the middle of the rear wheel while
pulling the wheel off the frame.
IMPORTANT: The rear wheel cannot be fitted to the frame if the parking brake is
engaged.
The front wheel is mounted, as standard, on the front fork. You can secure this easily
by placing the front fork with the swivelling wheel in the appropriate opening (image
7). Check whether the grey button (image 8) on the outside of the mounting is pressed
in completely and whether the wheel is secured properly. Repeat this process on the
opposite side with the other front wheel.
To remove the front fork and wheel, slide the black sliding button of the swivelling wheel
at the front (under the footplate) towards the side of the pushchair (image 9). You should
now see that the grey button on the outside of the mounting springs open. You can now
take the front fork out of the mounting.
Inflate the tyres of the EasyWalker QTRO with a pump for car tyres. The maximum
pressure for the tyres is 1.4 Bar (20 psi) (image 10).
TIP: You can buy a tapering converter at a bike shop so that you can use a bicycle pump
to inflate the EasyWalker QTRO’s tyres.
IMPORTANT: The maximum pressure for the tyres is 1.4 Bar (20 psi).
IMPORTANT: Ensure that all of the EasyWalker QTRO’s tyres are inflated equally. Unequal
tyre pressure can lead to instability of the EasyWalker QTRO and can impact upon the
safety and comfort of your child.
IMPORTANT: If the tyres have been over inflated, they may explode in hot weather. Make
sure you consider raised temperatures in the boot of your car or in a conservatory, for
example.
IMPORTANT: There may be grease on the axle, be careful with clothing and never let
children play with the wheels.
IMPORTANT: Do not leave the caps from the valves lying around. Prevent children putting
them in their mouths.
Seat
WARNING: Use a harness as soon as your child can sit unaided.
WARNING: The seat is not suitable for children under 6 months.
The EasyWalker QTRO is supplied with the seat and the storage basket already fitted. To
remove the seat, open the Velcro fastenings behind the footplate. Then open the poppers
on the fabric tapes, left and right on the back of the seat. Now open all other poppers
and Velcro fastenings on both sides of the seat (image 11).
To put the seat back onto the frame close the poppers and Velcro fastenings on both
sides of the seat. Close the Velcro fastenings behind the footplate. Finally, close the
poppers on the tapes at the back of the seat around the frame tubes, just above the rear
suspension. These tapes are part of the harness and provide extra comfort and security
for your child.
!
!
