18
C. Continuous Double-Face Hot laminating
( Figure 12 )
1) Front working table 2) Front top roller 3) Pressure-adjusting linkage
shaft 4) Top guiding roller 5)Top heat-sensitive film 6)Top film roller
7) Rear top roller 8) Rear bottom roller 9) Bottom film roller
10) Bottom heat-sensitive film 11) Bottom guiding roller 12) Front bottom
roller
A. How to adjust the friction of the roll film:
1) Put the loaded film rollers onto the front and rear supports separately. Pull the film
with your hands and feel some resistance.
2) Align the top and bottom films. If there is any difference, turn the right or left regulating
sleeve on the roller to get rid of it.
3) If fail in doing so, loosen the positioning sleeve and feed in the films again.
▲ Note:
If the films are not tight enough, you need to turn the regulating sleeve
To increase the friction.
B. How to feed in the films ( Shown as in Figure 12 ):
Turn the front and rear pressure-regulating hand-wheels separately to lift the
rollers up. Pull the films through between the two rollers and lay them on the
