14
When you open or close the folded hand-wheel, please pull the handgrip out a
little more first. Don’t force a turning so as to avoid possible damages.
▲
When the machine lies idle for a long
period of time
, please lift up the top
roller with the hand-wheel, so as to avoid distortion of the rubber
surface due to
high pressure.
Ⅹ
. Operation Instructions and Steps
This machine has a function of cold and hot single or double face
lamination, and can carry out the work with either sheet film or roll
film.
1. Continuous cold mounting:
A. How to adjust the damp of roll film
：
After load the roller onto the supporting plate, pull the film with your hands,
and you should feel certain resistance. If not meeting the requirement, turn to
adjust the orientation sleeve.
B. When the film is fed in, ( as shown in Figure 10 )
1) Lift up the top roller ( the rear roller is not in use while cold mounting ).
2) Turn the pressure-adjusting hand-wheel of the front roller, to raise the top
roller. Put the film through between the two rollers. Lay it on the rear
working table.
3) Pull the film plain with appropriate force, turn the pressure-adjusting
hand-wheel to let the roller down. And put the hand-wheel in a free
position—that is to say in a completely pressure-free state.
Mounting with cold film Double-face laminating
