Note 10
To use a window closer module with EC003, connect the module to the white/black lock control wire on
EC003 .
Using a window closer module with EC003
Note 11
Wiring method for fuel pump wire
The fuel pump wire is connecting with fuel pump or oil pump wire. If you can't find this wire in your car,
please connect it with constant 12V wire or tach wire in your car.
Wiring method for gray parking/hand brake wire.
If your car is manual transmission, connect the gray parking/hand brake wire with parking/hand brakewire
in the car
Note 12
If your car is automatic transmission, connect the gray parking/hand brake wire with chassis ground
If you connect with an electricity siren, such as 6 tone or 1 tone siren. Connect the pink wire with the
black wire from the siren and connect the other wire (usually a red wire) from siren to 12V wire.
Note 13
The pink wire for horn default is negative(-) output.
If your vehicle factory horn is negative, you can connect the pink wire with your factory car horn wire
directly.
If your car horn is positive output. Please add a SPST relay to change the polarity first, here is the
method:
When possible, place the siren on the same side of the vehicle as the control module, where its wires will
reach the control module’s wires without extending them. Always run the wires through the center of a
grommet, never through bare metal!
When installation the siren, please make sure which is downward for waterproof consideration
We do not recommend grounding the siren to its mounting screws. Instead, we recommend running both
the red and black wires into the passenger compartment and grounding to one common point for all
devices. Both wires are the same length and come already bonded together to make it easier. Whenever
possible, conceal your wires in the factory harnesses or in the same style loom as the factory.
Mount it where a thief cannot easily disconnect it, whether the hood is open or shut. Both the siren and
its wires should be difficult to find. This usually involves disguising the wire to look like a factory harness.
Engine start button color changes explanation
Operation
When armed
When disarmed
Turn on ACC
Turn ON
When engine started
When engine off
Button size(mm)
Engine start button reaction
Light turn off
Light turn off
Light is flashing
Light keeps flashing
Light stays on
Light turns off
Buttons introduction & function description:
LED indicator
Arm
Start button/panic
Disarm/trunk release
Spare key
1.Lock/Arm: press lock button once
6.Remote trunk release: keep pressing the unlock
button for 5 seconds
3.Remote engine start: In arm status, keep pressing
the start button for around 5 seconds.
5.Panic mode: short press start button once
4.Remote engine cut off: keep pressing the start
button for around 5 seconds.
2.Unlock/disarm: press unlock button once
7.Spare key( default is without, and we recommend
you to equip one for future emergency usage)
Blue color
Red color
Yellow color
28mm
40mm
52mm
∅
52 (with rubber)
∅
40(no rubber)
-10-
©
EASYGUARD
Electronics
.
All
right reserved.
-09-
©
EASYGUARD
Electronics
.
All
right reserved.
Connect with horn or siren 12V+
pink wire of EC003
Connect with
Connect with fused 12V+
connect 87A terminal on the SPDT relay.
Note: you can also use a SPDT relay, wiring method is the same as above, but no need to
