15
Gates remain
open after
systems
learn/one arm
stays open
and the other
one closed.
-
Ensure you have matched the + and - of
each ram to the equi and – motor
symbols on the board.
-
Clear any obstructions to the gates.
-
Make sure that the rams are going no
further than 100 degrees.
-
The dip switch setting should be set for a
double swing and not a single.
-
If LED 1 is a solid red hold systems learn
until it flashes. Then press the remote top
left hand button once.
-
Ensure the motors are locked in.
-
Increase the power amp settings by
following the dip switch settings (mentioned
above).
Gates not fully
opening or
closing
-
Ensure there is nothing obstructing the gate
or the rams.
-
If the gate is a bigger or heavier gate
change the power settings using the
dipswitches (1
st
set of dip switches). You
should not have to use the maximum power
setting. This is intended for a 500kg double
swing gate (or 250kg single).
-
Re-do the systems learn.
One gate
opens part of
the way/not
at all.
-
Make sure you are pressing the top left
hand button. The other buttons do have
their individual functions.
-
Dip Switch 7 setting has been set correctly.
-
Both rams are wired onto the control board
correctly. They should identical. I.E. black,
red. Black, red.
Single gate
LED 1 stays
on.
-
Dip switches 1 and 2 on bank 3 are ON
-
Dip Switch 7 on bank 1 is OFF
-
Battery clip is connected.
-
The motor is connected to MO1 and not
MO2
-
Press and hold SYS-LEARN for 3 seconds
until LED1 starts flashing again.
-
Press the remote once and wait until it
starts moving. This can take up to 5
seconds. Do NOT obstruct the learning
process. The gate will open and close
several times.
Remote/
keypad range
is less than
20M
-
Make sure the antenna is attached and
screwed in on the control board.
-
Make sure there is nothing obstructing the
antenna such as the power cable or motor
cables.
EasyGate Warranty Terms and Conditions
PLEASE READ THE FOLLOWING TERMS AND CONDITIONS OF USE CAREFULLY.
Warranty: This is a “Back to Base Warranty”
