Connect the battery cable to the battery. The electrical
installation is then complete.
Attach the housing cover of the base station.
6. Installation, electrical system
GB7
Check whether all cables have been properly laid,
firmly fastened without friction points and safely at-
tached.
E5 Basis
station
E6 Connecting
the
battery
The easydriver basic 2.3 is delivered with an illumi-
nated remote switch. It should preferably be installed in
the vicinity of the entrance door.
A hole with a 25 mm diameter is required for the
switch. Insert the cable with the PC-board plug through
this hole from the front. Firmly press the switch into the
drill hole. Glue the dome sticker over the switch. Lay
the cable to the base station. Ensure that the cable is
not kinked. Connect the PC-board connector to the
base station as shown in the figure.
easydriver basic 2.3:
Never swap the plus (+) and minus (-)
connection of the voltage supply!
English
